Removal of a convertible top from a 2000 Mazda Miata. I don't have video of the installation. Too much cussin'. Just sayin Power retractable hardtop (open) switch malfunction (stuck off) Power retractable hardtop (close) switch malfunction (stuck on) Open or short circuit in the wiring harness between the power retractable hardtop control module and the power retractable hardtop switch. Release of the top lock cannot be determined by the Power retractable The beloved Mazda MX-5 Miata roadster snags the No. 1 spot in our MotorTrend Ultimate Car Rankings, earning a score of 8.3 out of 10. But that mostly refers to the soft-top version. The RF I want to remove the MX-5 and Skyactive badge from the back of my ND2. I know they have 2-3 pins holding them in place. My question is how much (on average) would a shop charge for removing, plugging and color matching the holes where the pins were? Absolutely loving this car so far. Had her for about 5 days now, best purchase I’ve ever made! 2. Make sure you are using a number 3 screw driver. I bought one with a square shaft and used a wrench on it while pressing down as hard as I could. I was able to remove all but one of the bolts that way. The last one I tried sheared inside of the hard top. I was able to remove that one by drilling through the center of it heating it with a I'd get a set of bolt in Spec Miata brackets for your own use. Even OEM latches can pop loose on bumps and take up sunvisor space. A good bracket & hardware set is cheaper than used OEM latches and you won't have to worry about compatibility. Just make sure you're gentle removing the latches from the hardtop. Torque News checked our Craigs List to get a rough idea of the offerings. With zero effort we were able to spot a factory hardtop in red with original paint for $850 in the Bay Area near San It doesn’t sit flush against the hardtop, the whole bottom edge of the seal doesn’t sit against the hardtop and the cut is “flappy”. See less See more 2 FtFx0vs.